Design + measure
We measure the site, check your survey and setbacks, and lay out pattern, borders and drainage with samples on your Davie property.
Broward County paver contractor
Davie paver work ranges from long driveways on acreage lots to patios and pool decks in established neighborhoods. We plan the base, edge restraint and drainage, then take the job through the Town’s paver driveway review.
Request a free design consult ↗
Built for Davie
Many Davie properties are large, and a paver driveway on acreage often carries trucks, trailers and equipment, not just cars. We size the compacted base and edge restraint to how the drive is really used, so the pattern stays tight instead of rutting at the turn.
Drainage matters as much as the pattern. The Town asks for swale cross sections on driveway permits and wants the swale kept at least 3 inches deep, so we set paver elevations to move water toward the swale and away from the house, barn and pool.

Davie paver permits
We’re a State of Florida Certified General Contractor (CGC1527850). We prepare the permit package, submit it, and schedule every inspection. Here’s what the city looks for:
Sources: Town of Davie Paver/Concrete Driveway Checklist. Requirements change, so we confirm the current checklist with the city before every submittal.
Paver options in Davie
Most paver problems start below the surface. Every job gets a compacted base, bedding sand, a solid edge restraint and slope away from the house.
Concrete, brick or travertine pavers on a compacted base with a concrete edge restraint.
Paver and stone patios, garden paths and entry walks laid to drain away from the house.
Cool-to-the-touch stone and porcelain decks with matching coping.
Soldier courses, banded borders, bullnose steps and coping that finish the edges.
Pavers or stone slabs separated by artificial grass strips for a modern look.
Lift and relay sunken areas, refill joints and seal to protect color.
How a Davie paver job gets built
The base work in step three decides how the pavers look in ten years, so we never rush it.
We measure the site, check your survey and setbacks, and lay out pattern, borders and drainage with samples on your Davie property.
We prepare the Davie permit package and any HOA submittal, and schedule the work once approved.
We remove the old surface, excavate, then place and compact the base in lifts before screeding the bedding sand.
We lay and cut the pavers, set the edge restraint, sand and compact the joints, pass final inspection and seal when ready.
Our project work
Real photos from Concrete Solutions Today job sites. Each caption shows where the project was built.




Davie paver questions
Clear answers before you get quotes.
Yes for driveways. The Town uses one Paver/Concrete Driveway Checklist, reviewed by Planning & Zoning, Structural and Engineering, with a signed and sealed survey, a site plan, a Tree Affidavit and swale cross sections. We prepare and submit the full package.
Yes, when the base is built for it. On heavy-use drives we deepen and compact the base, use a thicker paver, and set a concrete edge restraint so the field can’t spread. Most paver failures we repair started with a thin base, not the pavers.
Often, yes, and pavers are easier to lift and reset if a utility ever needs access. The Town asks for a Hold Harmless agreement for work in a utility easement and drainage district approval for drainage easements, so we confirm both before design.
We usually recommend it after the joints have settled. A sealer helps lock joint sand, slows staining and fades the effect of sun on color. We tell you which product we used and when to reseal.
Start with the design
Send us a photo of the area and a rough size. We’ll schedule a site visit, bring samples, and walk you through layout, base, permit and timeline.